Reference Guide

Simple Network Management Protocol and Syslog | 897
Command
History
Usage
Information
When you enter no logging on, messages are logged only to the console.
Related
Commands
logging source-interface
s z
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog
server.
Syntax
logging source-interface interface
To disable this command and return to the default setting, enter no logging source-interface.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Syslog messages contain the IP address of the interface used to egress the router. By configuring the
logging source-interface command, the Syslog packets contain the IP address of the interface
configured.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Support added for S-Series
logging Enable logging to Syslog server.
logging buffered Set the logging buffered parameters.
logging console Set the logging console parameters.
logging monitor Set the logging parameters for the terminal connections.
S6000
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from
zero (0) to 16383.
• For the management interface on the RPM, enter the keyword
ManagementEthernet followed by the slot/port information. The slot range is
0-1 and the port range is 0.
• For a Port Channel, enter the keyword
port-channel followed by a number:
S-Series Range: 1-128
• For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Support added for S-Series