Reference Guide

Simple Network Management Protocol and Syslog | 883
Defaults
As shown
Command Modes
CONFIGURATION
Command
History
version 1 | 2c | 3
(OPTIONAL) Enter the keyword version to specify the security model
followed by the security model version number 1, 2c, or 3.
• Version 1 is the least secure version
• version
3 is the most secure of the security modes.
• Version
2c allows transmission of informs and counter 64, which allows for
integers twice the width of what is normally allowed.
Default: Version 1
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a
packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication and then
scrambling of the packet.
community-string
Enter a text string (up to 20 characters long) as the name of the SNMP
community.
Note: For version 1 and version 2c security models, this string
represents the name of the SNMP community. The string can be set
using this command, however it is recommended that you set the
community string using the snmp-server community command
before executing this command. For version 3 security model, this string
is the USM user security name.
udp-port
port-number
(OPTIONAL) Enter the keywords udp-port followed by the port number of
the remote host to use.
Range: 0 to 65535.
Default: 162
notification-type
(OPTIONAL) Enter one of the following keywords as the type of trap to be sent
to the host:
• bgp - Enable BGP state change traps
• ecfm - Enable ECFM state change traps
• entity - Enable entity change traps
• envmon - Enable SNMP environmental monitor traps
• eoam - Enable EOAM state change traps
• ets - Enable ets traps
• fips - Enable FIP Snooping state change traps
• isis - Enable ISIS adjacency change traps
• lacp - Enable LACP state change traps
• pfc - Enable pfc traps
• snmp - Enable SNMP traps
• stp - Enable 802.1d state change traps
• vlt - Enable VLT traps
• vrrp- Enable VRRP state change traps
• xstp - Enable 802.1s, 802.1w, and PVST+ state change traps
Version 9.0.2.0 Introduced on the S6000.