Reference Guide

Simple Network Management Protocol and Syslog | 879
snmp-server enable traps
s z
Enable and configure SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type] [notification-option]
command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS supports up to 16 SNMP trap receivers.
If this command is not configured, no traps controlled by this command are sent. If you do not specify
a notification-type and notification-option, all traps are enabled.
S6000
notification-type
Enter the type of notification from the list below:
• bgp - Enable BGP state change traps
• ecfm - Enable ECFM state change traps
• entity - Enable entity change traps
• envmon - Enable SNMP environmental monitor traps
• eoam - Enable EOAM state change traps
• ets - Enable ets traps
• fips - Enable FIP Snooping state change traps
• isis - Enable ISIS adjacency change traps
• lacp - Enable LACP state change traps
• pfc - Enable pfc traps
• snmp - Enable SNMP traps
• stp - Enable 802.1d state change traps
• vlt - Enable VLT traps
• vrrp- Enable VRRP state change traps
• xstp - Enable 802.1s, 802.1w, and PVST+ state change traps
notification-option For the envmon notification-type, enter one of the following optional
parameters:
• fan
• supply
• temperature
For the
snmp notification-type, enter one of the following optional parameters:
• authentication
• coldstart
• linkdown
• linkup
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Support added for S-Series; Added support for STP and xSTP notification types.