Reference Guide

878 | Simple Network Management Protocol and Syslog
www.dell.com | support.dell.com
If a community string is configured without a security-name (for example, snmp-server
community public ro), the community is mapped to a default security-name/group:
• v1v2creadu / v1v2creadg — maps to a community with ro permissions
• v1v2cwriteu/ v1v2cwriteg — maps to a community with rw permissions
This command is indexed by the community-name parameter.
If the snmp-server community command is not configured, you cannot query SNMP data. Only
Standard IPv4 ACL and IPv6 ACL is supported in the optional access-list-name.
The command options ipv6, security-name, and access-list-name are recursive. In other words,
each option can, in turn, accept any of the three options as a sub-option, and each of those sub-options
can accept any of the three sub-options as a sub-option, and so forth. The following example
demonstrates the creation of a standard IPv4 ACL called “snmp-ro-acl” and then assigning it to the
SNMP community “guest”:
Example
Figure 42-7. snmp-server community Command Example
FTOS(conf)# ip access-list standard snmp-ro-acl
FTOS(config-std-nacl)#seq 5 permit host 10.10.10.224
FTOS(config-std-nacl)#seq 10 deny any count
!
FTOS(conf)#snmp-server community guest ro snmp-ro-acl
FTOS(conf)#
Related
Commands
snmp-server contact
s z
Configure contact information for troubleshooting this SNMP node.
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact command.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Note: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP; TCP, ICMP rules are
not valid for SNMP. In IPv6 ACLs port rules are not valid for SNMP.
ip access-list standard Name (or select) a standard access list to filter based on IP address.
show running-config Display the current SNMP configuration and defaults.
S6000
text
Enter an alphanumeric text string, up to 55 characters long.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Support added for S-Series