Reference Guide

868 | sFlow
www.dell.com | support.dell.com
Command Modes
INTERFACE
Command
History
Usage
Information
When sFlow is enable on an interface, flow sampling is done on any traffic going out of the interface.
Related
Commands
sflow extended-switch enable
s z
Enable packing information on a switch only.
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable] command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS 9.0.2.0 and later enhances the sFlow implementation for real time traffic analysis to provide
extended gateway information in cases where the destination IP addresses are learned by different
routing protocols, and for cases where the destination is reachable over ECMP.
Related
Commands
sflow polling-interval (Global)
s z
Set the sFlow polling interval at a global level.
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Version 9.0.2.0 Introduced on S6000
Version 8.3.11.1 Introduced on Z9000
Version 7.7.1.0 Introduces on S-Series Stacking
Note: Once a physical port is a member of a LAG, it will inherit the sFlow configuration
from the LAG port.
sflow enable (Global) Turn sFlow on globally
S6000
enable Enter the keyword enable to enable global extended information.
Version 9.0.2.0 Introduced on S6000
Version 8.3.11.1 Introduced on Z9000
Version 7.7.1.0 Introduces on S-Series Stacking
sflow extended-switch enable Enable packing information on an extended gateway.
show sflow Display the sFlow configuration
S6000