Reference Guide

866 | sFlow
www.dell.com | support.dell.com
Commands
The sFlow commands are:
• sflow collector
• sflow enable (Global)
• sflow enable (Interface)
• sflow extended-switch enable
• sflow polling-interval (Global)
• sflow polling-interval (Interface)
• sflow sample-rate (Global)
• sflow sample-rate (Interface)
• show sflow
• show sflow linecard
sflow collector
s z
Specify a collector(s) to which sFlow datagrams are forwarded.
Syntax
sflow collector {ip-address | ipv6-address} agent-addr {ip-address | ipv6-address} [number
[max-datagram-size number]] | [max-datagram-size number]
To delete the specified collector(s), use the no sflow collector {ip-address | ipv6-address}
agent-addr {ip-address | ipv6-address} [number [max-datagram-size number]] |
[max-datagram-size number] command
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
S6000
{ip-address | ipv6-address}
Enter the IP address of the collector in dotted decimal format for
IPv4 or x:x:x:x::x format for IPv6.
Note: The :: notation specifies successive hexadecimal fields of
zeros
.
agent-addr {ip-address |
ipv6-address}
Enter the keyword agent-addr followed by the sFlow agent IP
address in dotted decimal format for IPv4 or x:x:x:x::x format for
IPv6.
Note: The :: notation specifies successive hexadecimal fields of
zeros
.
number
(OPTIONAL) Enter the udp port number (User Datagram
Protocol).
Range: 0 to 65535
Default: 6343
max-datagram-size number
(OPTIONAL) Enter the keyword max-datagram-size
followed by the size number in bytes.
Range: 400 to 1500
Default: 1400