Reference Guide

862 | Service Provider Bridging
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS must have the default CAM profile with the default microcode before you enable L2PT.
protocol-tunnel rate-limit
z
Enable traffic rate limiting per box.
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command.
Parameters
Defaults
75 frames per second
Command Modes
CONFIGURATION
Command
History
Example
Figure 40-2. protocol-tunnel rate-limit Command Example
FTOS#
FTOS#conf
FTOS(conf)#protocol-tunnel rate-limit 1000
FTOS(conf)#
Related
Commands
show protocol-tunnel
z
Display protocol tunnel information for all or a specified VLAN-Stack VLAN.
Syntax
show protocol-tunnel [vlan vlan-id]
Parameters
Defaults
No default values or behavior
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
rate
Enter the rate in frames per second.
Range: 75 to 3000
Default: 75
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.4.1.0 Introduced
show protocol-tunnel Display tunneling information for all VLANs
show running-config Display the current configuration.
S6000
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display information
for the one VLAN.
Range: 1 to 4094