Reference Guide

Service Provider Bridging | 861
Command
History
Example
Figure 40-1. Protocol-tunneling Command Example
FTOS#conf
FTOS(conf)#interface vlan 2
FTOS(conf-if-vl-2)#vlan-stack compatible
FTOS(conf-if-vl-2)#member Gi1/2-3
FTOS(conf-if-vl-2)#protocol-tunnel stp
FTOS(conf-if-vl-2)#
Usage
Information
Related
Commands
protocol-tunnel destination-mac
z
Overwrite the BPDU destination MAC address with a specific value.
Syntax
protocol-tunnel destination-mac xstp address
Parameters
Defaults
The default destination MAC is 01:01:e8:00:00:00.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When VLAN-Stacking is enabled, no protocol packets are tunneled.
Related
Commands
protocol-tunnel enable
z
Enable protocol tunneling globally on the system.
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Defaults
Disabled
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.4.1.0 Introduced
Note: When VLAN-Stacking is enabled, no protocol packets are tunneled.
show protocol-tunnel Display tunneling information for all VLANs
S6000
stp
Change the default destination MAC address used for L2PT to another value.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.4.1.0 Introduced
show protocol-tunnel Display tunneling information for all VLANs
S6000