Reference Guide

Security | 841
dot1x tx-period
s z
Configure the intervals at which EAPOL PDUs are transmitted by the Authenticator PAE.
Syntax
dot1x tx-period seconds
To return to the default, use the no dot1x tx-period command.
Parameters
Defaults
30 seconds
Command Modes
INTERFACE
Command History
show dot1x interface
s z
Display the 802.1X information on an interface.
Syntax
show dot1x interface interface
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command History
Example
Figure 39-5. show dot1x interface command Example
FTOS#show dot1x int Gi 2/32
S6000
seconds
Enter the interval time, in seconds, that EAPOL PDUs are transmitted.
Range: 1 to 65535
Default: 30
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S-Series.
S6000
interface
Enter one of the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/
port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the
slot/port information.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S-Series.