Reference Guide

Security | 831
Command History
ip tacacs source-interface
s z
Specify an interface’s IP address as the source IP address for TACACS+ connections.
Syntax
ip tacacs source-interface interface
To delete a source interface, enter no ip tacacs source-interface.
Parameters
Defaults
Not configured.
Command Mode
CONFIGURATION
Command History
tacacs-server host
s z
Specify a TACACS+ host.
Syntax
tacacs-server host {hostname | ip-address | ipv6-address} [port number] [timeout seconds] [key
key]
To remove a TACACS+ server host, use the no tacacs-server host {hostname | ip-address |
ipv6-address} command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Introduced on the S-Series.
S6000
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number
from zero (0) to 16838.
• For the Null interface, enter the keywords
null 0.
• For the Port Channel interface, enter the keyword
port-channel followed by a
number:
S-Series Range: 1-128
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Introduced on the S-Series.
S6000