Reference Guide

826 | Security
www.dell.com | support.dell.com
debug radius
z
View RADIUS transactions to assist with troubleshooting.
Syntax
debug radius
To disable debugging of RADIUS, enter no debug radius.
Defaults
Disabled.
Command Modes
EXEC Privilege
Command History
ip radius source-interface
z
Specify an interface’s IP address as the source IP address for RADIUS connections.
Syntax
ip radius source-interface interface
To delete a source interface, enter no ip radius source-interface.
Parameters
Defaults
Not configured.
Command Mode
CONFIGURATION
Command History
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from
zero (0) to 16838.
• For the Null interface, enter the keywords
null 0.
• For the Port Channel interface, enter the keyword
port-channel followed by a
number:
S-Series Range: 1-128
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000