Reference Guide

Rapid Spanning Tree Protocol (RSTP) | 801
max-age
z
Set the time interval for the RSTP bridge to maintain configuration information before refreshing that
information.
Syntax
max-age seconds
To return to the default values, enter no max-age.
Parameters
Defaults
20 seconds
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Related
Commands
protocol spanning-tree rstp
z
Enter the RSTP mode to configure RSTP.
Syntax
protocol spanning-tree rstp
To exit the RSTP mode, enter exit
Defaults
Not configured
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Example
Figure 38-2. protocol spanning-tree rstp Command
FTOS(conf)#protocol spanning-tree rstp
FTOS(config-rstp)##no disable
Usage
Information
RSTP is not enabled when you enter the RSTP mode. To enable RSTP globally on the system, enter no
description from the RSTP mode.
Related
Commands
S6000
max-age
Enter a number of seconds the FTOS waits before refreshing configuration information.
Range: 6 to 40 seconds
Default: 20 seconds
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
max-age Change the wait time before RSTP transitions to the Forwarding state.
hello-time Change the time interval between BPDUs.
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
description
Disable RSTP globally on the system.