Reference Guide

Rapid Spanning Tree Protocol (RSTP) | 799
FTOS#debug spanning-tree rstp bpdu gigabitethernet 2/0
?in Receive (in) out Transmit (out)
description
z
Enter a description of the Rapid Spanning Tree
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
SPANNING TREE (The prompt is “config-rstp”.)
Command
History
Related
Commands
disable
z
Disable RSTP globally on the system.
Syntax
disable
To enable Rapid Spanning Tree Protocol, enter no disable.
Defaults
RSTP is disabled
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Related
Commands
forward-delay
z
Configure the amount of time the interface waits in the Listening State and the Learning State before
transitioning to the Forwarding State.
Syntax
forward-delay seconds
To return to the default setting, enter no forward-delay.
S6000
description
Enter a description to identify the Rapid Spanning Tree (80 characters maximum).
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
protocol spanning-tree rstp Enter SPANNING TREE mode on the switch.
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
protocol spanning-tree rstp Enter the Rapid Spanning Tree mode
S6000