Reference Guide

788 | Remote Monitoring (RMON)
www.dell.com | support.dell.com
Command Modes
CONFIGURATION INTERFACE (config-if)
Command
History
rmon event
z
Add an event in the RMON event table.
Syntax
rmon event number [log] [trap community] [description string] [ownername]
To disable RMON on an interface, use the no rmon event number [log] [trap community]
[description string] command.
Parameters
Defaults
as described above
Command Modes
CONFIGURATION
Command
History
rmon hc-alarm
z
Set an alarm on any MIB object.
Syntax
rmon hc-alarm number variable interval {delta | absolute} rising-threshold value
event-number falling-threshold value event-number [owner string]
To disable the alarm, use the no rmon hc-alarm number command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
number
Assign an event number in integer format from 1 to 65535. The number
value must be unique in the RMON Event Table.
log (OPTIONAL) Enter the keyword log to generate an RMON log entry. The
log entry is triggered and sets the eventType in the RMON MIB to log or
log-and-trap.
Default: No log
trap community
(OPTIONAL) Enter the keyword trap followed by an SNMP community
string to configure the eventType setting in the RMON MIB. This sets either
snmp-trap or log-and-trap.
Default: public
description string (OPTIONAL) Enter the keyword description followed by a string
describing the event.
owner name
(OPTIONAL) Enter the keyword owner followed by the name of the
owner of this event.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000