Reference Guide

Router Information Protocol (RIP) | 777
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, enter no output-delay.
Parameters
Default
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
This command is intended for low-speed interfaces.
passive-interface
z
Suppress routing updates on a specified interface.
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
Although the passive interface will neither send nor receive routing updates, the network on that
interface will still be included in RIP updates sent via other interfaces.
Related
Commands
delay
Specify a number of milliseconds as the delay interval.
Range: 8 to 50
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
interface
Enter the following information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number from 1
to 32 for EtherScale, 1 to 255 for TeraScale, 1-128 on S-Series.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
neighbor Enable RIP for a specified network.
network Define a neighbor.