Reference Guide

Router Information Protocol (RIP) | 775
Command
History
Usage
Information
RIP supports a maximum of 16 ECMP paths.
neighbor
z
Define a neighbor router with which to exchange RIP information.
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are
possible.
Use the passive-interface command in conjunction with the neighbor command to ensure that only
specific interfaces are receiving and sending data.
Related
Commands
network
z
Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the
switch.
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameter
Defaults
No RIP network is configured.
Command Modes
ROUTER RIP
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
ip-address
Enter the IP address, in dotted decimal format, of a router with which to exchange
information.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
passive-interface Sets the interface to only listen to RIP broadcasts.
S6000
ip-address
Specify an IP network address in dotted decimal format. You cannot specify a subnet.