Reference Guide

772 | Router Information Protocol (RIP)
www.dell.com | support.dell.com
Command
History
Related
Commands
distribute-list out
z
Configure a filter for outgoing routing updates.
Syntax
distribute-list prefix-list-name out [interface | bgp | connected | isis | ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Related
Commands
ip poison-reverse
z
Set the prefix of the RIP routing updates to the RIP infinity value.
Syntax
ip poison-reverse
To disable poison reverse, enter no ip poison-reverse.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list.
S6000
prefix-list-name
Enter the name of a configured prefix list.
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number
from 1 to 32 for EtherScale, 1 to 255 for TeraScale, 1-128 on S-Series.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
connected (OPTIONAL) Enter the keyword connected to filter only directly connected
routes.
isis (OPTIONAL) Enter the keyword isis to filter only IS-IS routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually configured routes.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list.
S6000