Reference Guide

Control and Monitoring | 77
show processes ipc flow-control
s z
Display the Single Window Protocol Queue (SWPQ) statistics.
Syntax
show processes ipc flow-control [cp | rp1 | rp2 | lp linecard-number]
Parameters
* In the S-Series, this command supports only the cp keyword, not the rp1, rp2, and lp
options. See
Figure .
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
FTOS#s6000#show processes ipc flow-control
Q Statistics on CP Processor
TxProcess RxProcess Cur High Time Retr Msg A
ck Aval Max
Len Mark Out ies Sent Rc
vd Retra Retra
ACL0 RTM0 0 0 0 0 0
0 10 10
ACL0 DIFFSERV0 0 0 0 0 0
0 10 10
ACL0 IGMP0 0 0 0 0 0
0 10 10
ACL0 PIM0 0 0 0 0 0
0 10 10
ARPMGR0 MRTM0 0 0 0 0 0
0 100 100
show interfaces stack-unit Display information on all interfaces on a specific S-Series stack
member.
show processes memory
(S-Series)
Display CPU usage information based on processes running in an
S-Series
S6000
cp (OPTIONAL) Enter the keyword cp to view the Control Processor’s SWPQ
statistics.
rp1 (OPTIONAL) Enter the keyword rp1 to view the Control Processor’s SWPQ
statistics on Route Processor 1.*
rp2 (OPTIONAL) Enter the keyword rp2 to view the Control Processor’s SWPQ
statistics on Route Processor 2.*
lp linecard-number (OPTIONAL) Enter the keyword lp followed by the stack-unit number to
view the Control Processor’s SWPQ statistics on the specified stack-unit.*
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series.