Reference Guide

Router Information Protocol (RIP) | 767
36
Router Information Protocol (RIP)
Overview
Router Information Protocol (RIP) is a Distance Vector routing protocol. FTOS supports both RIP
version 1 (RIPv1) and RIP version 2 (RIPv2). The symbols s z under command headings indicate
which Dell Networking — , S-Series or Z-Series, respectively — support the command.
The FTOS implementation of RIP is based on IETF RFCs 2453 and RFC 1058. For more information
on configuring RIP, refer to the FTOS Configuration Guide.
Commands
The following commands enable you to configure RIP:
• auto-summary
• clear ip rip
• debug ip rip
• default-information originate
• default-metric
• description
• distance
• distribute-list in
• distribute-list out
• ip poison-reverse
• ip rip receive version
• ip rip send version
• ip split-horizon
• maximum-paths
• neighbor
• network
• offset-list
• output-delay
• passive-interface
• redistribute
• redistribute ospf
Note: The S-Series platform supports RIP with FTOS version 9.0.2.0 and later.
S6000