Reference Guide

Quality of Service (QoS) | 765
To remove an existing WRED profile, use the no wred-profile command.
Parameters
Defaults
The five pre-defined WRED profiles. When a new profile is configured, the minimum and maximum
threshold defaults to predefined wred_ge_g values.
If green profile is applied, default yellow also take effect and vice-versa.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use the default pre-defined profiles or configure your own profile. You can not delete the pre-defined
profiles or their default values and you can modify values in the default profile. This command enables
the WRED configuration mode—(conf-wred).
Related
Commands
wred-profile-name
Enter your WRED profile name in character format (16 character maximum). Or
use one of the pre-defined WRED profile names. You can configure up to 26
WRED profiles plus the 5 pre-defined profiles, for a total of 31 WRED profiles.
Pre-defined Profiles:
wred_drop, wred-ge_y, wred_ge_g, wred_teng_y, wred_teng_g
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
threshold Specify the minimum and maximum threshold values of the WRED profile