Reference Guide

Quality of Service (QoS) | 749
qos-policy-input
s z
Create a QoS input policy on the router.
Syntax
qos-policy-input qos-policy-name cpu-qos|layer2
To remove an existing input QoS policy from the router, use no qos-policy-input qos-policy-name
cpu-qos|layer2 command.
Parameters
Defaults
Layer 3
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use this command to specify the name of the input QoS policy. Once input policy is specified,
rate-police can be defined. This command enables the qos-policy-input configuration mode—
(conf-qos-policy-in).
Related
Commands
qos-policy-output
s z
Create a QoS output policy.
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use no qos-policy-output qos-policy-name command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
S6000
qos-policy-name
Enter your input QoS policy name in character format (32 character
maximum).
cpu-qos Enter the cpu-qos keyword to assign this ACL to control plane traffic only
(CoPP).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map.
Default: Layer 3
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000.
Version 9.0.2.0 Policy name character limit increased from 16 to 32.
rate-police Incoming traffic policing function
S6000
qos-policy-name
Enter your output QoS policy name in character format (32 character
maximum).
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000.
Version 9.0.2.0 Policy name character limit increased from 16 to 32.