Reference Guide

748 | Quality of Service (QoS)
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
Command
History
Usage
Information
Input policy map is used to classify incoming traffic to different flows using class-map, QoS policy, or
simply using incoming packets DSCP. This command enables policy-map-input configuration mode
(conf-policy-map-in).
When changing a “service-queue” configuration in a QoS policy map, all QoS rules are deleted and
re-added automatically to ensure that the order of the rules is maintained. As a result, the Matched
Packets value shown in the “show qos statistics” command is reset.
Related
Commands
policy-map-output
s z
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Usage
Information
Output policy map is used to assign traffic to different flows using QoS policy. This command enables
the policy-map-output configuration mode (conf-policy-map-out).
Related
Commands
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000.
Version 9.0.2.0 Policy name character limit increased from 16 to 32.
Version 7.4.1.0 Expanded to add support for Layer 2
service-queue Assign a class map and QoS policy to different queues.
policy-aggregate Allow an aggregate method of configuring per-port QoS via policy maps.
service-policy input Apply an input policy map to the selected interface.
S6000
policy-map-name
Enter the name for the policy map in character format (16 characters
maximum).
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000.
Version 9.0.2.0 Policy name character limit increased from 16 to 32.
service-queue Assign a class map and QoS policy to different queues.
policy-aggregate Allow an aggregate method of configuring per-port QoS via policy maps.
service-policy output Apply an output policy map to the selected interface.