Reference Guide

Quality of Service (QoS) | 747
Command
History
Usage
Information
You must first enter the class-map command in order to access this command. You can match against
only one VLAN ID.
Related
Commands
policy-aggregate
s z
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is
part of the policy map (input/output) applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use no policy-aggregate qos-policy-name command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (policy-map-input and policy-map-output)
This command is supported on S-Series, S6000 and S4810 under policy-map-input mode only.
Command
History
policy-map-input
s z
Create an input policy map.
Syntax
policy-map-input policy-map-name cpu-qos|layer2
To remove an input policy map, use the no policy-map-input policy-map-name cpu-qos|layer2
command.
Parameters
Defaults
Layer 3
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000.
class-map Create/access a class map.
S6000
qos-policy-name
Enter the name of the policy map in character format (32 characters maximum)
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000.
Version 9.0.2.0 Policy name character limit increased from 16 to 32.
S6000
policy-map-name
Enter the name for the policy map in character format (32 characters maximum).
cpu-qos Enter the cpu-qos keyword to assign this ACL to control plane traffic only
(CoPP).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map.
Default: Layer 3