Reference Guide

738 | Quality of Service (QoS)
www.dell.com | support.dell.com
On one interface, you can configure the rate police command for a VLAN or you can configure the rate
police command for an interface. For each physical interface, you can configure three rate police
commands specifying different VLANS.
rate shape
z
Shape the traffic output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
Defaults
Granularity for rate is Mbps unless the kbps option is used.
Command Modes
INTERFACE
Command
History
Related
Commands
service-class dynamic dot1p
s z
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or
on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes
INTERFACE mode entries.
Syntax
service-class dynamic dot1p
To return to the default setting, enter no service-class dynamic dot1p.
S6000
kbps
Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On
S-Series make the following value a multiple of 64. The default granularity is
Megabits per second (Mbps).
Range: 0 to 40000.
rate
Enter the outgoing rate in multiples of 10 Mbps.
Range: 0 to 40000
burst-KB
(OPTIONAL) Enter a number as the burst size in KB.
Range: 0 to 10000
Default: 50
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
rate-shape Shape traffic output as part of the designated policy.
S6000