Reference Guide

706 | Port Monitoring
www.dell.com | support.dell.com
description
z
Enter a description of this monitoring session
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Related
Commands
monitor session
z
Create a session for monitoring traffic.
Syntax
monitor session session-ID
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session command.
Parameters
Defaults
No default values or behaviors
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Example
Figure 32-1. Command Example: monitor session
FTOS(conf)# monitor session 60
FTOS(conf-mon-sess-60)
Usage
Information
All monitor sessions contain an implicit “mode interface,” that is, if no mode is designated, the mode is
set to interface as shown in the example above.
The monitor command is saved in the running configuration at the Monitor Session mode level and can
be restored after a chassis reload.
S6000
description
Enter a description regarding this session(80 characters maximum).
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
monitor session Enable a monitoring session.
S6000
session-ID
Enter a session identification number.
Range: 0 to 65535
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000