Reference Guide

PIM-Source Specific Mode (PIM-SSM) | 703
31
PIM-Source Specific Mode (PIM-SSM)
Overview
This chapter contains the following sections
• IPv4 PIM-Source Specific Mode Commands
The symbols s z under command headings indicate which Dell Networking — , S-Series
or Z-Series, respectively — support the command.
IPv4 PIM-Source Specific Mode Commands
The IPv4 PIM-Source Specific Mode (PIM-SSM) commands are:
• ip pim ssm-range
• show ip pim ssm-range
ip pim ssm-range
z
Specify the SSM group range using an access-list.
Syntax
ip pim ssm-range {access_list_name}
Parameters
Defaults
Default SSM range is 232/8 and ff3x/32
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS supports standard access list for the SSM range. Extended ACL cannot be used for configuring
SSM range. If an Extended ACL is configured and then used in the ip pim ssm-range {access list
name} configuration, an error is reported.
However, if ip pim ssm-range {access list name} is configured first and then the ACL is configured
as an Extended ACL, an error is not reported and the ACL is not applied to the SSM range.
S6000
S6000
access_list_name
Enter the name of the access list.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000