Reference Guide

702 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Incoming interface: TenGigabitEthernet 4/23, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 8/0
(*, 226.1.1.4), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags: SCJ
Incoming interface: TenGigabitEthernet 4/23, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 8/0
FTOS#
Table 30-3. show ip pim tib Command Example Fields
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM route table.
expires Displays the amount of time until the entry expires and is removed from
the database.
RP Displays the IP address of the RP/source for this entry.
flags List the flags to define the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = FTOS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = first packet from the last hop router is received and the entry is
ready to switch to SPT
• K=acknowledge pending state
Incoming interface Displays the reverse path forwarding (RPF) interface towards the RP/
source.
RPF neighbor Displays the next hop from this interface towards the RP/source.
Outgoing interface list: Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group.
• statically configured member of the Group.
• received a (*,G) Join message.