Reference Guide

PIM-Sparse Mode (PIM-SM) | 695
ip pim register-filter
s z
Use this feature to prevent a PIM source DR from sending register packets to an RP for the specified
multicast source and group.
Syntax
ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
The access name is an extended IP access list that denies PIM register packets to RP at the source DR
based on the multicast and group addresses. Do not enter this command before creating the access-list.
ip pim rp-address
s z
Configure a static PIM Rendezvous Point (RP) address for a group or access-list.
Syntax
ip pim rp-address address {group-address group-address mask} override
To remove an RP address, use the no ip pim rp-address address {group-address group-address
mask} override command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
S6000
access-list
Enter the name of an extended access list. Maximum 16 characters.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
S6000
address
Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address mask
Enter the keyword
group-address followed by a group-address mask, in
dotted decimal format (/xx), to assign that group address to the RP.
override Enter the keyword override to override the BSR updates with static RP. The
override will take effect immediately during enable/disable.
Note: This option is applicable to multicast group range.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.