Reference Guide

692 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
ip pim bsr-candidate
s z
Configure the PIM router to join the Bootstrap election process.
Syntax
ip pim bsr-candidate interface [hash-mask-length] [priority]
To return to the default value, enter no ip pim bsr-candidate.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
ip pim dr-priority
s z
Change the Designated Router (DR) priority for the interface.
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority command.
Parameters
Defaults
1
Command Modes
INTERFACE
S6000
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a number
from 0 to 16383.
• For Port Channel interface types, enter the keyword
port-channel followed by
a number from 1 to 255.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
hash-mask-length
(OPTIONAL) Enter the hash mask length.
Range: zero (0) to 32
Default: 30
priority
(OPTIONAL) Enter the priority used in Bootstrap election process.
Range: zero (0) to 255
Default: zero (0)
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
S6000
priority-value
Enter a number. Preference is given to larger/higher number.
Range: 0 to 4294967294
Default: 1