Reference Guide

Open Shortest Path First (OSPFv2) | 663
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
Figure 29-3. Command Example: router ospf
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
Usage
Information
You must have an IP address assigned to an interface to enter the ROUTER OSPF mode and configure
OSPF.
Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in
the system.
show config
z
Display the non-default values in the current OSPF configuration.
Syntax
show config
Command Modes
ROUTER OSPF
Command
History
Example
Figure 29-4. Command Example: show config
FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
FTOS(conf-router_ospf)#
show ip ospf
z
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf process-id [vrf vrf name]
process-id
Enter a number for the OSPF instance.
Range: 1 to 65535
vrf name
(Optional) Enter the VRF process identifier to tie the OSPF instance to the VRF. All
network commands under this OSPF instance are subsequently tied to the VRF instance.
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
S6000
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000
S6000