Reference Guide

656 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
Syntax
ip ospf transmit-delay seconds
To return to the default value, enter no ip ospf transmit-delay.
Parameters
Defaults
1 second
Command Modes
INTERFACE
Command
History
log-adjacency-changes
z
Set FTOS to send a Syslog message about changes in the OSPF adjacency state.
Syntax
log-adjacency-changes
To disable the Syslog messages, enter no log-adjacency-changes.
Defaults
Disabled.
Command Mode
ROUTER OSPF
Command
History
maximum-paths
z
Enable the software to forward packets over multiple paths.
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, enter no maximum-paths.
Parameters
Defaults
4
seconds
Enter the number of seconds as the transmission time. This value should be greater than the
transmission and propagation delays for the interface.
Range: 1 to 3600
Default: 1 second
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
S6000
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
S6000
number
Specify the number of paths.
Range: 1 to 32
Default: 4 paths