Reference Guide

642 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
Command Modes
EXEC Privilege
Command
History
Example
Figure 29-1. Command example: debug ip ospf process-id packet
FTOS#debug ip ospf 1 packet
OSPF process 90, packet debugging is on
FTOS#
08:14:24 : OSPF(100:00):
Xmt. v:2 t:1(HELLO) l:44 rid:192.1.1.1
aid:0.0.0.1 chk:0xa098 aut:0 auk: keyid:0 to:Gi 4/3 dst:224.0.0.5
netmask:255.255.255.0 pri:1 N-, MC-, E+, T-,
hi:10 di:40 dr:90.1.1.1 bdr:0.0.0.0
packet (OPTIONAL) Enter the keyword packet to debug only OSPF packet information.
spf (OPTIONAL) Enter the keyword spf to display the Shortest Path First information.
database-
timer
rate-limit
(OPTIONAL) Enter the keyword
database-timer rate-limit to display the LSA
throttling timer information.
Applies to the S4810 only.
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Table 29-1. Output Descriptions for debug ip ospf process-id packet
Field Description
8:14 Displays the time stamp.
OSPF Displays the OSPF process ID: instance ID.
v: Displays the OSPF version. FTOS supports version 2 only.
t: Displays the type of packet sent:
1 - Hello packet
2 - database description
3 - link state request
4 - link state update
5 - link state acknowledgement
l: Displays the packet length.
rid: Displays the OSPF router ID.
aid: Displays the Autonomous System ID.
chk: Displays the OSPF checksum.
aut: States if OSPF authentication is configured. One of the following is listed:
0 - no authentication configured
1 - simple authentication configured using the ip ospf authentication-key command)
2 - MD5 authentication configured using the ip ospf message-digest-key command.
auk: If the ip ospf authentication-key command is configured, this field displays the key used.
keyid: If the ip ospf message-digest-key command is configured, this field displays the MD5 key
to: Displays the interface to which the packet is intended.
dst: Displays the destination IP address.