Reference Guide

Multicast | 629
28
Multicast
Overview
This chapter contains the following sections:
• IPv4 Multicast Commands
The symbols s z under command headings indicate which Dell Networking — , S-Series
or Z-Series, respectively — support the command.
IPv4 Multicast Commands
The IPv4 Multicast commands are:
• clear ip mroute
• ip mroute
• ip multicast-routing
• ip multicast-limit
• show ip mroute
• show ip rpf
clear ip mroute
s z
Clear learned multicast routes on the multicast forwarding table. To clear the PIM tree information
base, use clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | *}
Parameters
Command Modes
EXEC Privilege
Command
History
S6000
S6000
group-address
[
source-address]
Enter multicast group address and source address (if desired), in dotted decimal
format, to clear information on a specific group.
* Enter * to clear all multicast routes.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.