Reference Guide

Multicast Source Discovery Protocol (MSDP) | 605
Defaults
Without any options, this command clears the entire source-active cache.
Command Modes
EXEC Privilege
Command
History
debug ip msdp
z
Turn on MSDP debugging.
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address | packet peer address |
pim} command.
Parameters
Defaults
Not configured
Command Modes
EXEC Privilege
Command
History
ip msdp cache-rejected-sa
z
Enable a MSDP cache for the rejected source-active entries.
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-rejected-sa {number}
command followed by the ip msdp cache-rejected-sa {number} command.
Parameters
Defaults
No default values or behavior
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
S6000
event peer address
Enter the keyword event followed by the peer address in a dotted decimal
format (A.B.C.D.).
packet peer address Enter the keyword packet followed by the peer address in a dotted decimal
format (A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
S6000
number
Enter the number of rejected SA entries to cache.
Range: 0 to 32766