Reference Guide

Link Layer Detection Protocol (LLDP) | 595
Parameters
Defaults
unconfigured
Command Modes
CONFIGURATION (conf-lldp)
Command
History
Related
Commands
advertise med guest-voice-signaling
s z
Configure the system to advertise a separate limited voice service for a guest user when the guest voice
control packets use a separate network policy than the voice data.
Syntax
advertise med guest-voice-signaling {vlan-id layer2_priority DSCP_value} | {priority-tagged
number}
To return to the default, use the no advertise med guest-voice-signaling {vlan-id layer2_priority
DSCP_value} | {priority-tagged number} command.
Parameters
Defaults
unconfigured
Command Modes
CONFIGURATION (conf-lldp)
vlan-id
Enter the VLAN ID.
Range: 1 to 4094
layer2_priority
Enter the Layer 2 priority.
Range: 0 to 7
DSCP_value
Enter the DSCP value.
Range: 0 to 63
priority-tagged number Enter the keyword priority-tagged followed the Layer 2 priority.
Range: 0 to 7
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
protocol lldp (Configuration) Enable LLDP globally.
debug lldp interface Debug LLDP.
show lldp neighbors Display the LLDP neighbors.
show running-config lldp Display the LLDP running configuration.
S6000
vlan-id
Enter the VLAN ID.
Range: 1 to 4094
layer2_priority
Enter the Layer 2 priority.
Range: 0 to 7
DSCP_value
Enter the DSCP value.
Range: 0 to 63
priority-tagged number Enter the keyword priority-tagged followed the Layer 2 priority.
Range: 0 to 7