Reference Guide

588 | Link Layer Detection Protocol (LLDP)
www.dell.com | support.dell.com
Command Modes
EXEC Privilege
Command
History
clear lldp neighbors
s z
Clear LLDP neighbor information for all interfaces or a specific interface.
Syntax
clear lldp neighbors {interface}
Parameters
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
debug lldp interface
s z
Enable LLDP debugging to display timer events, neighbor additions or deletions, and other
information about incoming and outgoing packets.
Syntax
debug lldp interface {interface | all}{events| packet {brief | detail} {tx | rx | both}}
To disable debugging, use the no debug lldp interface {interface | all}{events} {packet {brief | detail}
{tx | rx | both}} command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S-Series.
S6000
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/
port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitEthernet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
followed by the slot/port information.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S-Series.
S6000