Reference Guide

578 | Layer 2
www.dell.com | support.dell.com
Related
Commands
track ip
z
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member
interfaces.
Syntax
track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface command.
Parameters
Defaults
Not configured
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
When this command is configured, the VLAN is operationally UP if any of the interfaces specified in the track ip
command are operationally UP, and the VLAN is operationally DOWN if none of the tracking interfaces are
operationally UP.
If the track ip command is not configured, the VLAN's Layer 3 operational state depends on all the members of
the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 traffic is not affected by the track ip command
configuration.
Related
Commands
untagged
z
Add a Layer 2 interface to a VLAN as an untagged interface.
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface command.
interface vlan Configure a VLAN.
untagged Specify which interfaces in a VLAN are untagged.
S6000
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel .
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
interface vlan Configure a VLAN.
tagged Specify which interfaces in a VLAN are tagged.
S6000