Reference Guide

Control and Monitoring | 57
The password configured by the ip ftp password command is used when you use the ftp: parameter in
the copy command.
Related
Commands
ip ftp source-interface
s z
Specify an interface’s IP address as the source IP address for FTP connections.
Syntax
ip ftp source-interface interface
To delete an interface, use the no ip ftp source-interface interface command.
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
Related
Commands
ip ftp username
s z
Assign a user name for outgoing FTP connection requests.
copy Copy files.
ip ftp
username
Set the user name for FTP sessions.
S6000
interface Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback followed by a number
from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-channel followed by a
number:
S-Series: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by a number from 1
to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed
by the slot/port information.
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
copy Copy files from and to the switch.
S6000