Reference Guide

Layer 2 | 569
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS(conf)#do sh mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId Mac Address Type Interface State
2 00:00:00:00:00:01 Dynamic (N) Po 128 Active
2 00:00:00:00:00:02 Dynamic (N) Po 10 Active
2 00:00:00:00:00:03 Dynamic Po 100 Active
2 00:00:00:00:00:04 Dynamic Po 10 Active
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch. Optionally, you can also add
one of these combinations:
address/mac-address, interface/
interface, or vlan vlan-id.
static
(OPTIONAL) Enter the keyword static to display only those MAC address
specifically configured on the switch. Optionally, you can also add one of
these combinations:
address/mac-address, interface/interface, or
vlan vlan-id.
address mac-address (OPTIONAL) Enter the keyword address followed by a MAC address in
the nn:nn:nn:nn:nn:nn format to display information on that MAC address.
interface interface (OPTIONAL) Enter the keyword interface followed by the interface type,
slot and port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
S-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
interface interface-type (OPTIONAL) Instead of entering the keyword interface followed by the
interface type, slot and port information, as above, you can enter the
interface type, followed by just a slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display
the MAC address assigned to the VLAN.
Range: 1 to 4094.
count (OPTIONAL) Enter the keyword count, followed optionally, by an
interface or VLAN ID, to display total or interface-specific static addresses,
dynamic addresses, and MAC addresses in use.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.