Reference Guide

| 551
show config
Display the changes you made to the IS-IS configuration. Default values are not shown.
Syntax
show config
Command Modes
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Examples
Figure 23-2. Command Example: show config (router-isis mode)
FTOS(conf-router_isis)#show config
!
router isis
clns host ISIS 49.0000.0001.F100.E120.0013.00
log-adjacency-changes
net 49.0000.0001.F100.E120.0013.00
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
Figure 23-3. Command Example: show config (address-family-ipv6 mode)
FTOS(conf-router_isis-af_ipv6)#show conf
!
address-family ipv6 unicast
maximum-paths 16
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
show isis database
z
Display the IS-IS link state database.
Syntax
show isis database [level-1 | level-2] [local] [detail | summary] [lspid]
Parameters
S6000
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.
Identifies that Multi-Topology
IS-IS is enabled in transition mode
Identifies that Multi-Topology
IS-IS is enabled in transition mode
S6000
level-1
(OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2
(OPTIONAL) Displays the Level 2 IS-IS link-state database.
local
(OPTIONAL) Displays local link-state database information.
detail
(OPTIONAL) Detailed link-state database information of each LSP displays when
specified. If not specified, a summary displays.