Reference Guide

| 545
Defaults
Disabled
Command Mode
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Command
History
net
Use this mandatory command to configure an IS-IS network entity title (NET) for a routing process. If
a NET is not configured, the IS-IS process will not start.
Syntax
net network-entity-title
To remove a net, enter no net network-entity-title.
Parameters
Defaults
Not configured.
Command Modes
ROUTER ISIS
Command
History
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that
interface.
Syntax
passive-interface interface
To delete a passive interface configuration, enter the no passive-interface interface command.
Parameters
Defaults
Not configured.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.
S6000
network-entity-title
Specify the area address and system ID for an IS-IS routing process. The first 1
to 13 bytes identify the area address. The next 6 bytes identify the system ID.
The last 1 byte is the selector byte, always identified as zero zero (00). This
argument can be applied to an address or a name.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.
S6000
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For Loopback interface, enter the keyword
loopback followed by a number from
zero (0) to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a number
from 1 to 32 for EtherScale, 1 to 255 for TeraScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.