Reference Guide

52 | Control and Monitoring
www.dell.com | support.dell.com
Usage
Information
The default interval for the polling is 300 seconds (5 minutes). Use this command to enable the polling
and to configure the polling frequency.
end
s Z
Return to the EXEC Privilege mode from other command modes (for example, the
CONFIGURATION or ROUTER OSPF modes).
Syntax
end
Command Modes
CONFIGURATION, SPANNING TREE, MULTIPLE SPANNING TREE, LINE, INTERFACE,
TRACE-LIST, VRRP, ACCESS-LIST, PREFIX-LIST, AS-PATH ACL, COMMUNITY-LIST,
ROUTER OSPF, ROUTER RIP, ROUTER ISIS, ROUTER BGP
Command
History
Related
Commands
exec-banner
s z
Enable the display of a text string when the user enters the EXEC mode.
Syntax
exec-banner
To disable the banner on terminal lines, enter no exec-banner.
Defaults
Enabled on all lines (if configured, the banner appears).
Command Modes
LINE
Command
History
Usage
Optionally, use the banner exec command to create a text string that is displayed when the user
accesses the EXEC mode. This command toggles that display.
Version 8.3.11.1 Introduced on the Z9000 to replace the enable xfp-power-updates
command.
Version 8.3.10.0 Replacement command for S4810. Replaces the enable
xfp-power-updates
command.
S6000
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series.
exit Return to the lower command mode.
S6000
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series.