Reference Guide

Link Aggregation Control Protocol (LACP) | 511
Command
History
l
lacp port-priority
z
Configure the port priority to influence which ports will be put in standby mode when there is a
hardware limitation that prevents all compatible ports from aggregating.
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
Defaults
32768
Command Modes
INTERFACE
Command
History
lacp system-priority
z
Configure the LACP system priority.
Syntax
lacp system-priority priority-value
Parameters
Defaults
32768
Command Modes
CONFIGURATION
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0
Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G stack-units on ExaScale.
show lacp Display the lacp configuration
S6000
priority-value
Enter the port-priority value. The higher the value number the lower the priority.
Range: 1 to 65535
Default: 32768
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
S6000
priority-value
Enter the system-priority value. The higher the value, the lower the priority.
Range: 1 to 65535
Default: 32768
Version 9.0.2.0 Introduced on the S6000.