Reference Guide

Link Aggregation Control Protocol (LACP) | 509
22
Link Aggregation Control Protocol (LACP)
Overview
This chapter contains commands for Dell Networking implementation of Link Aggregation Control
Protocol (LACP) for the creation of dynamic link aggregation groups (LAGs — called port-channels
in FTOS parlance). For static LAG commands, the section Port Channel Commands in the Interfaces
chapter), based on the standards specified in the IEEE 802.3 Carrier sense multiple access with
collision detection (CSMA/CD) access method and physical layer specifications.
Commands in this chapter generally are supported by FTOS on all Dell Networking systems as
indicated by the characters that appear below each command heading: ,
z Z-Series, or
.
Commands
Use the following commands for LACP:
• clear lacp counters
• debug lacp
• lacp port-priority
• lacp system-priority
• port-channel mode
• port-channel-protocol lacp
• show lacp
In addition, an FTOS option provides hitless dynamic LACP states (no noticeable impact to dynamic
LACP states after an RPM failover).
clear lacp counters
z
Clear Port Channel counters.
Syntax
clear lacp port-channel-number counters
Parameters
S6000
S6000
port-channel-number
Enter a port-channel number:
S-Series Range: 1 to 128