Reference Guide

IPv4 Routing | 505
Usage Information
The F10 Monitoring MIB provides access to the statistics described below.
show tcp statistics
Z
View information on TCP traffic through the switch.
Syntax
show tcp statistics {all | cp | rp1 | rp2}
Parameters
Command Modes
EXEC Privilege
Command History
Example
Figure 21-21. show tcp statistics cp Command Example
FTOS#show tcp stat cp
Control Processor TCP:
Rcvd: 10585 Total, 0 no port
0 checksum error, 0 bad offset, 0 too short
329 packets (1263 bytes) in sequence
17 dup packets (6 bytes)
Table 21-12. F10 Monitoring MIB
Command Display Object OIDs
IP statistics:
Bcast:
Received
Sent
f10BcastPktRecv
f10BcastPktSent
1.3.6.1.4.1.6027.3.3.5.1.1
1.3.6.1.4.1.6027.3.3.5.1.2
Mcast:
Received
Sent
f10McastPktRecv
f10McastPktSent
1.3.6.1.4.1.6027.3.3.5.1.3
1.3.6.1.4.1.6027.3.3.5.1.4
ARP statistics:
Rcvd:
Request
Replies
f10ArpReqRecv
f10ArpReplyRecv
1.3.6.1.4.1.6027.3.3.5.2.1
1.3.6.1.4.1.6027.3.3.5.2.3
Sent:
Request
Replies
Proxy
f10ArpReqSent
f10ArpReplySent
f10ArpProxySent
1.3.6.1.4.1.6027.3.3.5.2.2
1.3.6.1.4.1.6027.3.3.5.2.4
1.3.6.1.4.1.6027.3.3.5.2.5
S6000
all Enter the keyword all to view all TCP information.
cp Enter the keyword cp to view only TCP information from the Control Processor.
rp1 Enter the keyword rp1 to view only TCP statistics from Route Processor 1.
rp2 Enter the keyword rp2 to view only TCP statistics from Route Processor 2.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 6.4.1.0 Introduced