Reference Guide

50 | Control and Monitoring
www.dell.com | support.dell.com
Defaults
1
Command Modes
EXEC Privilege
Command
History
do
s z
Allows the execution of most EXEC-level commands from all CONFIGURATION levels without returning to the
EXEC level
.
Syntax
do command
Parameters
Defaults
No default behavior
Command Modes
CONFIGURATION
INTERFACE
Command
History
Usage
Information
The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
FTOS(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with FTOS(conf-if-te-5/0)#
reload [confirm yes/no]: n
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000.
Version 8.3.7.0 Introduced on S4810.
Version 7.6.1.0 Introduced on S-Series.
S6000
command Enter an EXEC-level command.
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series.