Reference Guide

496 | IPv4 Routing
www.dell.com | support.dell.com
Parameter
Command Modes
EXEC
EXEC Privilege
Command History
Example
Figure 21-12. show ip interface Command Example
FTOS#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
FTOS#
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Loopback interface, enter the keyword
Loopback followed by a number
from 0 to 16383.
• For the Management interface, enter the keyword
ManagementEthernet
followed by zero (0).
• For the Null interface, enter the keyword
null followed by zero (0).
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
S-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces and
whether an IP address is assigned.
linecard
slot-number
(OPTIONAL) Enter the keyword linecard followed by the number of the stack-unit
slot.
Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i, and 0 to 5 on a E300
Note: This keyword is not available on the S-Series.
configuration (OPTIONAL) Enter the keyword configuration to display the physical interfaces
with non-default configurations only.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Table 21-7. show ip interface Command Example Items
Lines Description
TenGigabitEthernet 0/0... Displays the interface’s type, slot/port and physical and line protocol
status.
Internet address... States whether an IP address is assigned to the interface. If one is, that
address is displayed.
IP MTU is... Displays IP MTU value.