Reference Guide

IPv4 Routing | 495
Parameters
Command Modes
EXEC
Command History
Usage Information
This command provides egress port information for a given IP flow. This is useful in identifying which
interface the packet will follow in the case of Port-channel and Equal Cost Multi Paths. Use this
command for routed packed only. For switched packets use the show port-channel-flow command
show ip flow does not compute the egress port information when load-balance mac hashing is also
configured due to insufficient information (the egress MAC is not available).
S-Series produces the following error message:
%Error: Unable to read IP route table
show ip interface
z
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief | linecard slot-number] [configuration]
vrf instance
Show only the L3 flow as they apply to that VRF process.
interface interface Enter the keyword interface followed by of the following interface
keywords.
• For a Fast Ethernet interface, enter the keyword
FastEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• (OPTIONAL) Enter an in or out parameter in conjunction with the
optional interface:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
source-ip address Enter the keyword source-ip followed by the IP source address in IP
address format.
destination-ip address Enter the keyword destination-ip followed by the IP destination address in
IP address format.
protocol number [tcp |
udp] | icmp
Enter the keyword protocol followed by one of the protocol type
keywords:
tcp, udp, icmp or protocol number
src-port number Enter the keyword src-port followed by the source port number.
destination-port number Enter the keyword destination-port followed by the destination port
number.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
S6000