Reference Guide

494 | IPv4 Routing
www.dell.com | support.dell.com
Command Mode
EXEC
EXEC Privilege
Command History
Example
Figure 21-11. show ip fib stack-unit Command Example
FTOS#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr
Port VId EC
------------------ --------------------------- -----------------
------------------- -------- ----- --
10.10.10.10/32 Direct, Nu 0 0.0.0.0
00:00:00:00:00:00 BLK HOLE 0 0
FTOS>
Related
Commands
show ip flow
z
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
Syntax
show ip flow interface [vrf vrf instance] interface {source-ip address destination-ip address}
{protocol number [tcp | udp] | icmp} {src-port number destination-port number}
longer-prefixes (OPTIONAL) Enter the keyword longer-prefixes to view all routes with a
common prefix.
summary (OPTIONAL) Enter the keyword summary to view the total number of prefixes in
the FIB.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Modified: Added support for up to seven stack members.
Table 21-6. show ip fib stack-unit Command Example Fields
Field Description
Destination Lists the destination IP address.
Gateway
Displays either the word
Direct and an interface for a directly connected route or the
remote IP address to be used to forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
EC Displays the number of ECMP paths.
clear ip fib stack-unit Clear FIB entries on a specified stack-unit
S6000