Reference Guide

492 | IPv4 Routing
www.dell.com | support.dell.com
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
4200-1 (perm, OK) - IP 192.68.69.2
1230-3 (perm, OK) - IP 192.68.99.2
ZZr (perm, OK) - IP 192.71.18.2
Z10-3 (perm, OK) - IP 192.71.23.1
FTOS#
Related
Commands
show ip cam stack-unit
z
Display content-addressable memory (CAM) entries for an S-Series switch.
Syntax
show ip cam stack-unit id port-set pipe-number [ip-address mask [longer-prefixes] | summary]
Parameters
Table 21-4. show hosts Command Example Fields
Field Description
Default domain... Displays the domain name (if configured).
Name/address lookup... States if DNS is enabled on the system.
If DNS is enabled, the Name/Address lookup is domain service.
If DNS is not enabled, the Name/Address lookup is static mapping.
Name servers are... Lists the name servers, if configured.
Host Displays the host name assigned to the IP address.
Flags Classifies the entry as one of the following:
• perm - the entry was manually configured and will not time out
• temp - the entry was learned and will time out after 72 hours of inactivity.
Also included in the flag is an indication of the validity of the route:
• ok - the entry is valid.
• ex - the entry expired.
• ?? - the entry is suspect.
TTL Displays the amount of time until the entry ages out of the cache. For dynamically
learnt entries only.
Type Displays IP as the type of entry.
Address Displays the IP address(es) assigned to the host.
traceroute View DNS resolution
ip host Configure a host.
S6000
id
Enter the stack-unit ID.
Unit ID range:
S4810: 0-11
all other S-Series: 0-7
pipe-number
Enter the number of the Port-Pipe number.
S50n, S50V range: 0 to 1; S25N, S25P, S25V range: 0 to 0